Relative to the gasket Plate Heat Exchanger Gaskets everyone is not unfamiliar, as for its installation method may not be so familiar, today we will talk about the plate Heat Exchanger Gasket three common installation methods, hope in the plate heat exchanger gasket installation, can be handy. Plate heat exchanger gaskets can be divided into three forms according to the different installation methods: (1) Direct paste type, that is, after applying sealant on the sealing gasket, it is directly glued to the installation slot of the heat exchange plate. (2) Glue nail Mosaic type, that is, the assembly hole is designed on the heat exchange plate, and the rubber nail is designed on the side of the sealing gasket. After the sealing gasket is placed in the installation slot, the rubber nail is embedded in the assembly hole. (3) Buckle type, that is, there is a buckle on the side of the sealing gasket, and the sealing gasket is installed on the heat exchange plate with the buckle. Different applications, the performance of plate heat exchanger gasket is also different, just like if the user wants to get a higher heat transfer efficiency, the general use of the gasket will use diagonal flow form; If you want to save costs, it will use the form of unilateral flow, etc., below to specifically understand the specific form of plate heat exchanger gasket in different occasions! Plate heat exchanger plate is divided into unilateral flow and diagonal flow according to its heat exchange medium flow form, corresponding, plate heat exchanger sealing gasket according to the heat exchange medium flow form is divided into unilateral flow and diagonal flow. The unilateral flow of the plate heat exchanger gasket means that the heat exchange medium flowing into the right corner hole of the heat exchange plate flows out from the right corner hole, and the heat exchange medium flowing into the left corner hole flows out from the left corner hole. Diagonal flow means that the heat exchange fluid flows from the right corner hole and then flows out from the left corner hole, or the fluid flowing from the left corner hole flows out from the right corner hole, showing a diagonal flow mode. In terms of heat transfer efficiency, the diagonal flow mode is better than the unilateral flow, but the cost of using the unilateral flow mode is relatively low, so in the case of meeting the heat transfer efficiency, the unilateral flow form is generally used.
Jiangsu Baode offers you Brazed Plate Heat Exchanger, Gasket Plate Heat Exchanger, Shell And Tube Heat Exchanger, etc.
